Donnerstag, 29. Dezember 2011

Asus eeePC X101 with OSX Snow Leopard 10.6 - 10.6.6

The next step was with my original retail DVD of Snow Leopard. Of course it wouldn't boot, I had expected that. However, I was quite surprised when it even did not boot with the help of iBoot or EFI Empire because I wasn't able to switch the discs - "F5" just didn't work. Finally I managed to start the installation by dividing the task to an external HD with an image of the DVD and OSX86ModCD from the external DVD-drive.

To tell it right away - it was not a real successful installation: The resolution stayed at 800x600 thru the whole process and I was not  able to get a higher res up to now (v10.6.7). But that's not the worst - wifi isn't working either.
At least the system is booting from scratch thanks to OSX86ModCD. The N455 is recognized falsely as an Intel Core Solo. RAM is correctly shown. Audio is not working as far as I can tell. However, Ethernet is working (Atheros L1) but you'll lose the mouse - it is jumping around like a pinball after you connected Ethernet. Right now I am updating via ethernet to 10.6.8 but actually I have no hope anything will change after that.
It's the kernel that's for sure. That's why I am going to try either Lion or a manipulated kernel next.
Asus eeePC X101 with OS X 10.6.5
Bei meinem nächsten Versuch nahm ich meine Original-DVD zur Hand. Überraschenderweise ließ sie sich trotz Hilfsmittel wie iBoot oder EFI Empire nicht booten - die "F5"-Taste bewirkte rein gar nichts, also konnte ich die Disk nicht tauschen. Zuguterletzt probierte ich es mit einer externen HD, auf die ich zuerst ein Image der Installations-DVD schob und OSX86ModCD vom externen DVD-Laufwerk.

Um es kurz zu machen: Die Auflösung von 800x600, die ich am Anfang des Installationsprozesses angezeigt bekam, blieb leider bis zuletzt (bis 10.6.7) bestehen. Aber das war noch nicht einmal das Schlimmste, denn das WLAN-Modul wurde nicht erkannt.
Wenigstens bootete das Image sofort mit OSX86ModCD, wobei die N455 CPU allerdings fälschlicherweise als Intel Core Solo gesehen wird. Das RAM ist allerdings korrekt als DDR3 dargestellt. Audio funktioniert nicht, soweit ich feststellen kann 8oder aber es muss unhörbar leise sein). Ethernet funktioniert korrekt (Atheros L1-Chip), aber es stellte sich sofort nach der Verbindung ein bizarres Phänomen ein: Die Maus zickt seither rum und springt bei Berührung enervierend durch den Bildschirm. (Wobei so eine Art Echo-Effekt eintritt und man das Gefühl bekommt, der Echo-Zeiger hätte die korrekte Auflösung von 1024x600 ...) 
Das Update auf 10.6.8 via Ethernet führte dazu, dass das System seitdem gar nicht mehr startet. drei Stunden Arbeit sind also für die Katz gewesen. (Was sie aber ohne WLAN und richtiger Auflösung sowieso war.)

Ich denke, ich brauche ein passenden Kernel für das X101.

3 Kommentare:

  1. Some successful Snow Leopard installs:

    http://www.osx86.net/10-7-lion/13164-asus-eeepc-x101h.html

    AntwortenLöschen
  2. Hello! Excuse me if i'm bothering you but i have to ask you some information. I've just bought the new Asus eee pc x101ch and it has the new Intel Atom N2600 processor. My question is: do you think it's possible to install os x on it? Graphic card is GMA 3600 by the way. Thank you! However, you're doing a good job with this blog, you don't know how much people you help!! Cheers..

    AntwortenLöschen
    Antworten
    1. i don't know about the GMA3600 - you have to look if there's a Mac that runs with that graphics. If no then your chances are quite low. However, you could give it a try by using an USB with OSX on it in a store. If it won't start up you'll definetly know. If yes and there is an acceptable resolution after booting your chances are very good.

      Löschen